John Walters

[John Walters]

I think in question #2. Since current takes the path of least resistance. It should go through L1 TO H1 in the infinite switch ( go through the jumper wires ,the first path ) . Then it would go through the lights bimetal switch (Second path ).

[John Walters]

It looks like black is line. I was stumped on why. I looked at both schematics and seen that it look as though red,blue and green were added on the main PCB board ( on the left). I did not see any voltage on the PCB heater board. That’s why I issues with this .

[John Walters]

That was the only question, that I had wrong. I really want to know what it was,for knowledge.

[John Walters]

I can’t see anything showing ,that it switches.

[John Walters]

Yes

[John Walters]

Yes. Question#9. On schematic exercises : control boards 3

[John Walters]

I put that the relay switches line . That’s what I put.

[John Walters]

In the same test .they refer to the the relay switching line . I don’t think that relays can switch ground or neutral . That would defeat the purpose of the thermal fuses. It’s not there to monitor ,it’s to take small Vdc and send high voltage.

[John Walters]

Green

[John Walters]

Thanks

[John Walters]

Can I check this on the board?

[John Walters]

If the light is blown

[John Walters]

I got it .thank you!

[John Walters]

Gauge wires , is what I meant.

[John Walters]

Yes it’s helps, thanks!

[Author]

Posts