I have a question: Module 5, Unit 9, question #4: At which points on the relay board will we test tco?
I think the answer is DLB to PR1, but I am not sure why.
Is it because we are trying to see if there is ohms resistance from those two points?
Mid term question 7
When I am looking at the circuit, is the diode that is open- that is in the upper right hand corner of the schematic correct? So if that is correct then question 1: decrease- the current would stop going to the bake element 2. No change because there isn’t an open on that branch and the 120 vac needs to equal 120 vac. 3. No change- current is flowing through the load 4. Decrease because one branch is open and the current isn’t flowing through it decreasing the total current
Is that correct?
Mid Term Question 8
After doing a little bit more reading my question/statement is: The Ignitor, booster and Main are on a parallel circuit so each load in question will be on its own branch so they all have the same voltage of 120 vac. The Voltage drop should be 120 vac for each load because in each branch must equal to the source of power, 120 volts. Is that correct?